Installation Of Wood Prints

This durable product is great for decoration as well as branding. You may showcase it using the different installation methods and accessories presented below.

Installation With Standoffs

Step 1: Make sure the surface you chose is flat.

Step 2: Mark the wall using the pre-drilled holes of the product.

Step 3: Drill holes on the marks accordingly and insert anchors.

Step 4: Screw the standoff barrels onto the anchors.

Step 5: Align the pre-drilled holes on the product with the standoff barrels.

Step 6: Slide the pre-drilled holes on the product over the barrels.

Step 7: Screw the standoff caps onto the barrels.

Step 8: Make sure the product is firmly sandwiched between the barrels and the caps.

Installation With Command Strips

Step 1: Remove the cover from the adhesive part on one side of the strips.

Step 2: Apply the strips with the exposed adhesive to the back of your product.

Step 3: Remove the cover adhesive layer from the other side.

Step 4: Apply the product to the target area by pressing the areas with strips against it.

Step 5: Gently pull the product away from the installation area by its base.

Step 6: Unbind the command stips from each other and set the product aside.

Step 7: Leave the strips to firmly attach to their surfaces for at least one hour.

Step 8: Apply the product back to the surface by reattaching the strips.

Installation With Zip Ties

Step 1: Get zip ties according to the numbers of pre-drilled holes on the product.

Step 2: Pass the zip ties through the holes.

Step 3: Attach the zip ties to the installation area.

Step 4: Tighten the product with the zip ties for a firm grip.

Step 5: Cut off the extra ends of the zip ties for a neat look.

Installation With Easel Backs

Step 1: Take the easel backs and fold the wings to open the pre-dotted areas.

Step 2: Fold down the circular easel stabilizers to secure the wings into their slots.

Step 3: Remove the tape covers from the adhesive parts of the easel backs.

Step 4: Adhere the easel backs to both sides of the product.

Step 5: Press and hold the easel backs for a few seconds to make sure they’re secure.