Installation of Large Canvas Prints

This product can be mounted through various methods listed below using accessories available in our design tool menu.

Installation With Command Strips

Step 1: Use a measuring tape and mark the application area.

Step 2: Take a pair of strips and remove the tape on one side

Step 3: Attach one command strip to each corner of the product edges.

Step 4: Remove the backing tapes off the strips fixed to the product.

Step 5: Press the product with exposed strips to your pre-marked surface.

Step 6: Detach strips from each other by gently lifting the product from the bottom. 

Step 7: Wait an hour to make sure the strips are securely fixed to the surface.

Step 8:  Reattach the strips by lining up and pressing the product to the wall strips.

To remove the strips from the wall and the product, slowly pull the strip in a downward direction. Keep stretching up to 15 inches and the strips will release from the surface.

Installation With a Hanging Kit

A hanging kit is a collection of tools that will help you easily hang your illustration. The kit includes a saw tooth bracket, 2 screws, a hook, a nail and two sticky pads which will not be visible from the back of the product.

Step 1: Choose an area for installation and hammer a nail to the wall.

Step 2: Take the sawtooth bracket and screw it on the back of the wooden structure. Position the bracket upside down, so it won’t peek out from the back of the product.

Step 3: Now that you have both the illustration and the wall ready for the installation, just hang your product on the nail via the bracket.

Installation With Pole Pockets

We offer this product with a pole pocket on the top and bottom. Use these pockets to hang the product through a pole, rope or a similar accessory.

Step 1: Take the product and open the pole pockets.

Step 2: Pass the hanging accessory through the pockets.

Step 3: Hang the illustration from anywhere you might like.

Installation With Zip Ties

Step 1: Choose the number of zip ties to match the number of grommets.

Step 2: Pass the zip ties through the grommets to hang up the illustration.

Step 3: Tighten the zip ties on all the grommets.

Step 4: Snap so there is no wiggle room left.

Step 5: Cut the extra tips of the zip ties for a neater look.

Installation With Hanging Clips

Step 1: Take the hanging clips and pass them through the grommets on the product.

Step 2: Pass the clips through the grommets to hang the product in place.

Installation With Ropes

Step 1: Choose the number of ropes according to the number of grommets.

Step 2: Pass the ropes through the grommets to affix the illustration into place.

Step 3: Tighten the ropes to keep the product secure in its place.