Installation of Opaque Window Decals

 

Dry Mounting Application

The quickest way to apply your graphics is by dry mounting. Note that it’s necessary to take the right measurements prior to application. 

Step 1: Make sure to clean the surface before application.

Step 2: Remove the backing paper from the product.

Step 3: Adhere the graphics to the target surface area.

Step 4: Use a squeegee or a plastic card to flatten it and get rid of air bubbles.

 

Dry Application for Large Window Graphics

For the application of large displays, you’ll need a squeegee (or any thin rigid plastic like a credit card), scissors and masking tape.

Step 1: Place the graphics on the target surface with the backing paper still on.

Step 2: Stick masking tape down the center of the graphics to hold them in place.

Step 3: Step back to make sure the position meets your requirements. 

Step 4: Gently peel off the backing from one side until you reach the center tape line.

Step 5: Use scissors to cut away the loose backing paper.

Step 6: Carefully attach the exposed part to the surface and flatten it with a squeegee.

Step 7: Remove the masking tape that secures the graphics in their place.

Step 8: Lift the unattached part and slowly peel off the remaining backing paper.

Step 9: Use the same technique to apply the second half. 

Step 10: Squeegee going from the center out to get rid of air bubbles.

 

Wet Mounting Application

Wet mounting allows you to reposition the decal during application and achieve a smooth finish with ease. 

Step 1: Clean the application surface with a soft towel and liquid glass cleaner. 

Step 2: Take a spray bottle of soapy water and spray it onto the application surface.

Step 3: Remove the backing paper of the graphics.

Step 4: Spray the soapy water onto the adhesive part of the material.

Step 6: Place the graphics over the desired area and start applying it to the surface.

Step 7: Reposition the product by gently sliding it along the surface if needed.

Step 8: Even it out with a squeegee or a plastic card to get rid of air bubbles.

Step 9: Dry the surface with a soft cloth for a final application.

If you want to fully reposition the graphics during the application, quickly peel them off and apply onto the desired area. Spray more soap water if needed.